Page 1 of 1
Roll alignment
Posted: Sat Apr 14, 2018 4:55 am
by oxident
Hi!
I'm facing the issue that every print on either roll source/size is misplaced by about 2-3mm to the left. Could it be a hardware problem or can it be adjusted manually?
Re: Roll alignment
Posted: Thu May 03, 2018 10:38 am
by Dmaynard
Before you start making any adjustments, make sure the paper is not undersized. For the past year we have been getting rolls that are 1/8 to 1/4 inch undersized, sometimes more. Its random. One pallet of paper may only have 1 or 2 bad rolls, where as half of the rolls on the next pallet may be undersized. This is true for our brand of paper, OCE paper and HP paper, since its all coming from the same processing plant.
Re: Roll alignment
Posted: Thu May 03, 2018 1:20 pm
by oxident
Thanks for this hint. Our current paper (Xerox branded) is indeed over-/undersized. Do you think this might cause a constant shift (always towards the same side) of about 1/4 inch?
Re: Roll alignment
Posted: Fri May 04, 2018 12:40 pm
by Mark in Vegas
You may want to look in to using another supplier. We have switched over to Roll Bond Converting, look it up. We were using Dietzgen and the jamming in the lower loop was excessive even after making changes to the roof assembly suggested by HP support. Since changing suppliers the jam rate is almost "0" daily. We have three PW's out on the floor so that almost completely eliminates the possibility of the jamming being printer related. I also understand that there are only 2 or 3 mills left in the US that suppliers are using (so I'm told) so your experience may be different. I did a spot check of the paper we have in house and the width varies less than 1 mm roll to roll. We are not connected to Roll Bond in any way other than being a customer.
Re: Roll alignment
Posted: Wed Sep 12, 2018 1:29 am
by oxident
To be honest, I don't think it's a paper issue because I'm seeing the same drift across all rolls in every drawer. The service manual doesn't mention this but there has to be some kind of printhead-to-roll calibration...
Re: Roll alignment
Posted: Mon May 03, 2021 8:04 am
by valentindu16
Dmaynard wrote: ↑Thu May 03, 2018 10:38 am
Before you start making any adjustments, make sure the paper is not undersized. For the past year we have been getting rolls that are 1/8 to 1/4 inch undersized, sometimes more. Its random
Garde Meubles Marseille. One pallet of paper may only have 1 or 2 bad rolls, where as half of the rolls on the next pallet may be undersized. This is true for our brand of paper, OCE paper and HP paper, since its all coming from the same processing plant.
Thank you very much for this tip. I'll try to see if it really works.